恒溫水槽介紹：材料經本水槽一定時間之溫水浸漬試驗后，觀察是否變質，表面有無起泡、褪色、膨脹等現象，以判暄品質，亦可計算試驗前后之重量變化率。Soak specimen in warm after a specified time then observe whether specimen surface had degenerative conditions as blister,fadeaway,swell. etc.to judge its quality and calculate the change rate of weight before/after test.溫度Temp 常溫room temp.100℃攪拌馬達Mixer Motor 40W內槽Interior 30*20*25cm體積Dimension 54.5*39*52cm重量Weight 32kg 電源Power 1∮,AC 220V,12A恒溫水槽：本在試驗漆包線或以橡膠、塑膠制成之絕緣體或被覆。浸漬于本機規定溫度之試驗油中，經一定之時間后取出絕緣體或被覆，測試其位伸殘余率，漆包線則檢視其膜品質。This machine is to test the enameled wire or insulator insulator ＆ sheathin-g which are made of rubber or plastic,Immerse specimen in warm oil after time ,the take out specimen for testing its residual rate of tension.For the enameled wire ,it detect the quality of varnish film.二、恒溫水槽規格1.溫度:常溫～300℃。2.試料容積：試杯6個，Ф38mm，深300mm3.體積：57 40 53cm .4.重量：25kg.5.電壓：220V.